This procedure explains how to configure the display of the count from the last 5 seconds to the tenth of a second on a 24s Controller from Stramatel (ref. SC24 / UF452SC24).
At the time of the switching on of the desk 24 s, the system proposes to choose the mode of display of the stopwatch:
| Touch to | Selected mode | Description |
|---|---|---|
| 1 | 1/10 s | The Last 5 seconds The count is displayed in tenths (e.g. 4.9, 4.8, ... 0.0). |
| 4 | 1 s | The count remains in full seconds (classic display). |
🕐 The choice remains active as long as the desk remains powered.
It will only be requested again at the next restart up.
After selecting the mode 1/10 s:
Launches a count from 7 seconds Approximately.
Look at the display of the ShotClocks : 5.0 s, the display must switch to Tenths of a second (4.9 → 0.0).
At 0.0 s, check the triggering of The Horn and of the Red dot shows end of possession.
| Function | Touch |
|---|---|
| Start / Stop of the count | 1 |
| Discount to 14 s | 3 (re-press to cancel if more out of 14) |
| Discount to 24 s | 4 (re-press to cancel if out of 24) |
| Manual correction of time | Maintain 3or 4, then use 2 (-)/3 (+) and validate 1 |
1/10 s" mode complies with the FIBA regulations: display in tenths only in the last 5 seconds.
Some older models of 24s desks may not display the "1/10s" choice at startup. In this case, the setting is managed by a Internal factory parameter.
If the choice does not appear to ignition:
Cut / turn on Only the 24 s controller after turning on the board and main desk.
Check the Software version from desk 24 s, and its serial number and contact Stramatel.
| Action | Order |
|---|---|
| Choosing display at startup | button 1 → 1/10 s or button 4 → 1 s |
| Start / Stop of 24 s | 1 |
| Reset 14 s | 3 |
| Reset 24 s | 4 |
| Manual correction | Maintaining 3 or 4, then 2 (-)/3 (+), validate 1 |
| Test display tenth | Start a count → check switch to 5 s |